Locating Data Link Connector; Connect The Tool - Bosch OBD1300 Guide De Démarrage Rapide

Masquer les pouces Voir aussi pour OBD1300:

Les langues disponibles

6 | Quick Start Guide

3.2 Locating Data Link Connector

• The Data Link Connector (DLC) is usually located

under the driver's side dash for OBD II Vehicles and

GM OBD I.

• For Ford, Chrysler, and Toyota OBD I Vehicles the

(DLC) is usually found in the engine compartment.

• Refer to User's Guide for DLC location and OBD I

optional cables available for purchase.

• For more information on OBD II DLC locations, go to http://www.

obdclearinghouse.com/oemdb.

NOTE: When using the OBD II cable, power to the tool comes from the vehicle.

1. Connect Data Link Connector cable to the tool.

2. Connect Data Link Connector to vehicle.

3. Connect cigarette lighter cable if needed.

4. Place ignition key in the ON position and have the engine running or OFF.

5. Select Vehicle Diagnostics from Main Menu.

6. Select AutoID for model year 2000 and newer vehicles. If the vehicle

doesn't support AutoID than Manual vehicle selection will automati-

cally be entered. The tool can support up to 5 previous vehicles in the

garage and the tool will display them on the menu after Manual. If you

already have 5 vehicles in your garage, the tool will display a menu

asking you which previous vehicle to replace with the currently identi-

fied vehicle.

7. After vehicle selection has been completed, press

to review the Quick Test Results, if applicable.

8. Go to the Diagnostic Menu by pressing

575610 Rev B | 03.2016

to continue on

Bosch Automotive Service Solutions Inc.

English

Table des Matières