Maintenance Cont'd
Oval Air cleaner
Ê
1. Loosen screws
and lift cover
2. Carefully remove pre-cleaner
Í
and cartridge assembly
.
3. After servicing pre-cleaner and cartridge, as-
semble pre-cleaner on cartridge.
4. Install cartridge/pre-cleaner assembly in base
5. Place cover on air cleaner and tighten screws
securely to base.
Spark plug service (see fig.
)
DO NOT check for spark
with spark plug removed.
Use only Briggs & Stratton
Spark Tester
for spark.
DO NOT crank engine with spark plug removed. If
engine is flooded, place throttle in FAST and crank until
engine starts.
Ë
Spark plug gap
should be .76 mm or 0.030 in.
Replace spark plug every 100 hours or every season,
whichever occurs first. Spark tester and spark plug
wrench are available from any Authorized Briggs &
Stratton Service Dealer.
Note: In some areas, local law requires using a resistor
spark plug to suppress ignition signals. If this engine
was originally equipped with resistor spark plug, use
same type of spark plug for replacement.
Keep engine clean (see fig.
)
Periodically remove grass and chaff build-up from
engine. Clean finger guard. Do not spray engine with
water to clean because water could contaminate fuel.
Clean with a brush or compressed air.
Note: On string trimmer applications, clean accumu-
lated debris at each refueling, sooner if needed
Accumulation of debris around muf-
Ì
fler
could cause a fire. Inspect
and clean before every use.
If muffler is equipped with spark arrester screen,
remove spark arrester screen for cleaning and inspec-
tion. Replace if damaged.
Note: Over time debris may accumulate in cylinder
cooling fins and cannot be observed without partial
engine disassembly. For this reason, we recommend
that you have an authorized Briggs & Stratton Service
Dealer clean the air cooling system per recommended
intervals. (See Maintenance Schedule below.) Equally
important is to keep top of engine free from debris. (See
Keep engine clean above.)
Maintenance Schedule
Follow the hourly or calendar intervals, whichever
occur first. More frequent service is required when
operating in adverse conditions noted below.
First 5 Hours
D Change oil
Every 5 hours or daily
D Check oil level
D Clean debris
Ë
.
D Clean around muffler
Ì
(if equipped)
Every 25 hours or every season
D Change oil if operating under heavy load or high
ambient temperature
D Service air cleaner*
Î
.
Every 50 hours or every season
D Change oil
D Inspect spark arrester, if equipped.
Every 100 − 300 hours
D Clean combustion chamber***
*
Clean more often under dusty conditions, or
when airborne debris is present or after pro-
Ê
, to check
longed operation cutting tall, dry grass.
** On string trimmer applications:
clean debris at each refueling, sooner if needed;
have qualified technician clean air cooling
system every 30 hours, every season, sooner
if needed, especially in high debris conditions.
*** See an Authorized Briggs & Stratton Service
Dealer.
Partial List of Genuine Briggs & Stratton Parts
Part
Oil (20 oz.)
. . . . . . . . . . . . . . . . . . . . . . . .
Oil pump kit (uses standard electric drill
to remove oil from engine quickly)
Ì
Fuel stabilizer (1 oz., 30 ml single use pouch) 5058A
.
Fuel stabilizer (4.2 oz., 125 ml bottle)
Fuel filter
. . . . . . . . . . . . . . . . . . . .
Flat air cleaner cartridge
Flat air cleaner pre-cleaner
Oval air cleaner cartridge
Oval air cleaner pre-cleaner
Resistor spark plug
Standard spark plug
Long life platinum spark plug
(used on most L-head engines)
Spark tester
. . . . . . . . . . . . . . . . . . . . . . . .
Spark plug wrench
Spark arrester
Storage
Engines stored over 30 days need to be protected or
drained of fuel to prevent gum from forming in fuel
system or on essential carburetor parts.
**
Briggs & Stratton (or equivalent)
Part No.
100005
. . . . .
5056
. . . . .
5041A
298090 (5018)
. . . . . . . . .
491588 (5043)
. . . . . . . . . . . .
493537
. . . . . . . . . . . . . .
497725
. . . . . . . . . . . .
273185
. . . . . . . . . . . . . . . . .
802592E
. . . . . . . . . . . . . . . . .
492167
. . . . . . . . . . . . .
5062
19368
. . . . . . . . . . . . .
89838 (5023)
. . . . . . . . . . . . . . . . . . . . . .
398067
4
For engine protection, we recommend use of Briggs &
Stratton Fuel Stabilizer available from an Authorized
Briggs & Stratton Service Dealer. Mix stabilizer with fuel
in fuel tank or storage container. Run engine for a short
time to circulate stabilizer through carburetor. Engine
and fuel can be stored up to 24 months.
Note: If stabilizer is not used or if engine is operating on
gasoline containing alcohol, e.g. gasohol, remove all fuel
from tank and run engine until it stops from lack of fuel.
1. While engine is still warm, drain oil from crank-
case. Refill with fresh oil of recommended SAE
viscosity grade. (see fig.
)
2. Remove spark plug and pour about 15 ml (1/2
oz.) of engine oil into cylinder. Replace spark plug
and crank slowly to distribute oil.
3. Clean grass and chaff from cylinder and cylinder
head fins, under finger guard and around muffler.
4. Store in a clean and dry area, but NOT near a
stove, furnace or water heater which uses a pilot
light or any device that can create a spark.
Service
See an Authorized Briggs & Stratton Service Dealer.
Each one carries a stock of Genuine Briggs & Stratton
Parts and is equipped with special service tools.
Trained mechanics assure expert repair service on all
Briggs & Stratton engines. Only dealers advertising as
Authorized Briggs & Stratton" are required to meet
Briggs & Stratton standards.
When you purchase equipment pow-
ered by a Briggs & Stratton engine, you
are assured of highly skilled, reliable
service at more than 30,000 Authorized
Service Dealers worldwide, including
more than 6,000 Master Service Techni-
cians. Look for these signs wherever
Briggs & Stratton service is offered.
You may locate your nearest Authorized Briggs & Stratton
Service Dealer in our dealer locator map on our web site
www.briggsandstratton.com
or in the
Pages™" directory under Engines, Gasoline"
or Gasoline Engines," or Lawn Mowers" or
™
similar category.
Note: Walking fingers logo and Yellow Pages" are
registered trademarks in various jurisdictions.
An illustrated shop manual includes Theories of
Operation," common specifications and detailed in-
formation covering adjustment, tune-up and repair of
Briggs & Stratton L-head, single cylinder, 4 cycle
engines. Order P/N 270962 from an Authorized Briggs
& Stratton Service Dealer.
Insist on Genuine Briggs & Stratton replacement parts
with our logo on the box and/or part. Non-original parts
may not perform as well and may void your warranty.
Yellow