What To Do If - Zanussi ZYB590 Notice D'utilisation

Shelf Support Rails
Removing the shelf support rails
1
Pull the front of the
shelf support rail away
from the side wall.

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The oven does not heat up
The display shows an error
code "F.."
The oven lamp does not op-
erate
Steam and condensation set-
tle on the food and in the oven
cavity
If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.
34
2
1
2
Pull the rear shelf sup-
port rail away from the side
wall and remove it.
Possible cause
The oven is switched off
The clock is not set
The necessary settings are not set
The automatic switch off is on
The switch-on lock is on
The fuse in the fuse box is released
Demo mode is on
There is an electronic fault.
The oven lamp is defective
You left the dish in the oven for too long Do not leave the dishes in the oven for
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must
point to the front!
Switch on the oven
Set the clock
Check the settings
Refer to "Automatic switch off"
Refer to "Switching off the switch-on
lock"
Check the fuse
If the fuse is released more than one time,
contact a qualified electrician
Refer to "Demo mode"
Write down the error code and contact
the Service Center.
Replace the oven lamp
longer than 15-20 minutes after the
cooking process ends
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
Remedy