Zanussi ZYB590 Notice D'utilisation page 26

Clock function
End
Duration and End
time, if the oven is to be switched on and off auto-
matically later. In this case first set Duration
End .
Additional functions
Control Beep
Switching off the control beep
1. Stop the oven with the On/Off control
2. Touch and hold the
time, until a sound operates (approximately 2 sec-
onds).
Oven temperature
30 °C -120 °C
120 °C - 200 °C
200 °C -250 °C
250 °C -maximum °C
After an automatic cut-out, switch off the oven fully. Then
you can switch it on again.
Important! If you set the clock function Duration
End , the automatic cut-out switches off.
Switch-on lock
When the switch-on lock is set, you can not operate
the oven.
Switching on the switch-on lock
1. Stop the oven with the On/Off control
2. Push Selection
display shows "SAFE". The switch-on lock is switch-
ed on.
Switching off the switch-on lock
To switch off the switch-on lock, obey the same proce-
dure.
26
To set the switch-off time for an oven function.
can be used at the same
.
and controls at the same
.
and at the same time, until the
Application
The control beep does not operate.
Switching on the control beep
, then
1. Touch and hold the
time, until a sound operates (approximately 2 sec-
onds).
2. The control beep operates again.
Automatic cut-out
The appliance switches off after some time:
• if you do not switch off the appliance;
• if you do not change the oven temperature.
The last temperature set flashes in the temperature dis-
play.
Residual Heat function
With Duration function, the oven automatically switches
off some minutes before the time period is completed. The
or
oven uses the residual heat to complete the cooking with-
out energy consumption.
Important! Residual heat function is applicable only if the
Duration is more than 15 minutes.
Rapid heat-up function
With Rapid heat-up function you decrease the pre-heating
time. You can use it with each cooking function.
Important! Do not put the food into the oven, until Rapid
heat up is completed.
1. Set an oven function.
If necessary, change the recommended temperature.
2. Push
heat-up function operates.
and controls at the same
Switch-off time
12.5 h.
8.5 h.
5.5 h.
3.0 h.
button. The display shows "FHU" and Rapid