Switching On - IKA IKAMAG RET control visc Mode D'emploi

foil key mode
foil key
visc
Ill. 1
Mains
ON / OFF
LED Power
LED Temp

Switching on

The instrument is switched on by the mains switch on the left side of the
instrument (see Ill. 1).
After the instrument has been switched on, the LED „power" and the
LED's „Temp" and „Mot" blink for a short time and this indicate that a
self-test is carried out. In this test all safety relevant funktions are
checked.
A - Mode of Operation
All display segments of the digital dis-
play blink thrice at the same time.
Then the mode of operation is display-
ed. A -mode of operation for about
2 sec.
RET cv 0498
foil key temp
digital display LED Motor
Mode
Visc
On
Power Temp °C
Off
0..300 0..1100
Dial Temp Rotary knob Temp Dial Motor
foil key motor
The set safety temperature (preset to
300°C at our Works) is displayed. SV
is blinking.
After the termination of the self-test
RET control-visc
IKA LABORTECHNIK
the display changes to SAFE OK.
On
Mot B - Mode of Operation
Off
Switching on as described under A -
mode of operation.
The digital display shows the following
images:
All display segments blink three times.
Rotary knob Motor
B -mode of operation is displayed for
about 5 seconds.
The set safety temperature (preset to
300°C at our Works), SAFE OK and
are displayed.
C - Mode of Operation
Switching on as described under A
-mode of operation.
The digital display shows the following
images:
All display segments blink three times.
The C -mode of operating is display-
ed for about 5 seconds.
The set safety temperature (preset to
300°C at our Works), SAFE OK and
are displayed.
17