Commissioning; Switching On - IKA ULTRA_TURRAX Mode D'emploi

8

Commissioning

Pay attention to the ambient conditions listed in the "Technical
Data".
If these conditions are met, the unit is ready
for operating when the mains plug has been
plugged in.
Fit the tube carefully and ensure it is
properly attached.
If above procedures are not followed,
safe operation can not be guaranteed
and/or the equipment may be damaged.
9

Switching on

 Press "Power" button (A) to switch on the device, see Fig. 1.
 The start-up screen will be displayed for several seconds. This screen
shows the unit designation and the software version.
 Then, the system check screen will be displayed for several seconds.
Symbols are shown on the screen, including the working mode set-
ting, the target speed, the maximum rotation speed (rpm) and timer
maximum value etc. of the device.
Symbols Explanation
 Maximum rotation speed of the device (If "Turbo" function is
activated, the maximum rotation speed could reach 8000 rpm).
 Rotation symbol (The symbol will change into  or  if "Rev"
function is activated).
 Rotation speed setting.
 Operation mode.
 "Timer" maximum value of the device.
 "Timer" symbol.
 After the system check screen, the working screen will appear
and the device is ready for operation.
Note: Figure above shows specified values corresponding to the
default settings at delivery.






21