Commissioning; Switching On - IKA ULTRA -TURRAX Tube Drive P control Mode D'emploi

The NAMUR commands and the additional specific IKA commands
commissioning serve only as low level commands for communica-
tion between the tube driver and the PC. With a suitable terminal
or communications program these commands can be transmitted
directly to the tube driver. The IKA software package, labworldsoft,
provides a convenient tool for controlling tube driver and collecting
data under MS Windows, and includes graphical entry features, for
motor speed ramps for example.
The following table summarize the (NAMUR) commands under-
stood by the tube drive control up to Version 2.9.
Abbreviation used:
m = Numbering parameter (integer)
X = 4 Speed
Commands Function
IN_NAME Request designation.
Start the Remote control
function.
RESET Switch to normal operation
IN_PV_X Read actual speed value
X=4
IN_SP_X Read target value input
X=4
OUT_SP_X m Set target speed value, input:
X=4 rpm
START_X Switch on appliance remote
X=4 function.
Start value function with setting.
IN_SOFTWARE Request software ID,
number, date and version
8
Pay attention to the ambient conditions listed in the "Technical
Data".
Fit the tube carefully and ensure it is
properly attached.
If above procedures are not followed,
safe operation can not be guaranteed
and/or the equipment may be dam-
aged.
Remark
Device Keypad not avail-
able except "power"
button is pressed, after
9
this command is sent to
device. "Remote" symbol is
displayed.
 Press "Power" button (A) to switch on the device, see Fig. 1.
Device Keypad available  The start-up screen will be displayed for several seconds. This screen
again, and clear the "Re-
shows the unit designation and the software version.
mote" symbol.

Commissioning

If these conditions are met, the unit is ready
for operating when the mains plug has been
plugged in.

Switching on

20