Beta 1899A Mode D'emploi page 9

INSTRUCTIONS FOR USE
DPF/FAP® CLEANING MACHINE SAFETY
- In case of contact of additives with painted surfaces, flush with water immediately.
- The machine must always stand on a flat surface, both while in operation and when not in use, to prevent any aggressive liquids
from spilling; a trolley should be used as a support.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING CLEANING MACHINE
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR EYE PROTECTION WHILE OPERATING THE MACHINE.
ALWAYS WEAR PROTECTIVE GLOVES AGAINST CHEMICAL AGENTS.
Additional personal protective equipment to wear according to the values found in the environmental
hygiene/risk analysis survey if the values exceed the limits under current regulations.
TECHNICAL DATA
1) Display
2) Start button (START)
3) Increase (↑) / Decrease (↓) buttons for cycle duration
4) Stop button (STOP)
5) Tank cap
6) 12 Volt power supply terminals
7) Quick coupler for DPF/FAP® pipe
Tank cap
12 Volt power supply terminals
Quick coupler for DPF/FAP® pipe
Tank cap
12 Volt power supply terminals
375 mm
230 mm
152 mm
1 L
12V battery
EN
9