Siemens 1FT6 03 Série Mode D'emploi page 85

Force ventilated, SH 132
Air flow direction from ND to NDE.
The air is blow through the enclosure corners of the extruded profile using a
mounted radial fan.
Connection:
Supply voltage:
Maximum current:
Force ventilated, SH 160
Air flow direction from ND to NDE.
The air is blow through the enclosure corners of the extruded profile using a
mounted radial fan.
Connection:
Supply voltage:
Maximum current:
Minimum clearance between parts and components mounted by the customer and the
air discharge opening
The following minimum clearance must be maintained between parts and compo-
nents mounted by the customer and the air discharge opening:
Table 1-13
Shaft height [mm]
 Siemens AG 2004 All rights reserved
Synchronous Servomotors, 1FT6 (PFT6) – 02.04 Edition
Through the terminal box
3–ph. 400/480 V AC, 50/60 Hz
0.4 A
Through the terminal box
3–ph. 400/480 V AC, 50/60 Hz
0.8 A
Minimum clearance to parts and components
mounted by the customer
Minimum clearance [mm]
80
100
132
160
20
30
60
80
Motor Description
1.7 Cooling
1FT6/1-33