Dialling Stored Numbers From The Phone Book; Call Duration Display; Switching The Handset On And Off; Range Information - switel BDT700 Mode D'emploi

4.5

Dialling stored numbers from the phone book

After you have stored a few phone numbers, you can call these up very quickly and easily.
1. Press the phone book button
alphabetical order.
2. You can now select all of the stored numbers with the
To choose a phone number directly alphabetically, press the appropriate letter.
3. Now press the call button
automatically dialled.
4.6

Call duration display

The call duration in minutes and seconds is shown in the display during a call. Fifteen
seconds after dialling, the display will switch from showing the number dialled to showing
the duration of the call. The call duration will still be retained in the display for a few seconds
after the call has been ended.
4.7

Switching the handset on and off

You can switch off the handset by pressing and holding the
switched off, no battery power will be used. It will not be possible to receive calls.
Press the button once to switch the handset on again. The display will show the
message BASE 1 and the handset will switch on again after a short time. The handset will
switch itself on automatically as soon as you replace it on the base station.
4.8

Range information

The range of the handset is ca. 50 metres in closed rooms and ca. 300 metres outdoors.
When there is a good contact with the base station, the
display.
If you are too far away from the base station, the
warning tones. In this case, move nearer to the base station once more, as otherwise the
call will be interrupted. These warning tones can be switched off as described in Chapter
8.8.
108
- Operation -
. The display will now show the first number stored in
and the telephone number displayed will be
symbol will flash and you will hear
and buttons.
button. If the handset is
symbol will come on in the