Making Calls; Dialling Stored Numbers From The Phone Book; Call Duration Display; Switching The Handset On And Off - switel D6025 Mode D'emploi

4.3

Making calls

1. Enter the required telephone number with a maximum of 32 digits using the number pad. As the display is
only capable of showing 12 digits, in the case of longer phone numbers only the last 12 digits are displayed.
Note: If you have entered a number incorrectly, you can delete the number by repeatedly pressing the
The number is completely deleted by pressing the
2. Press the call button
Note: You can also get a dialling tone by first pressing the call button
phone number, your telephone will dial the number directly. With this method of making a call, it is not possible to
correct individual digits in the number in the manner described above.
4.4

Dialling stored numbers from the phone book

After you have stored a few phone numbers, you can call these up very quickly and easily.
1. Press the phone book button
2. You can now select all of the stored numbers with the
To choose a phone number directly alphabetically, press the appropriate letter.
3. Now press the call button
4.5

Call duration display

The call duration in minutes and seconds is shown in the display during a call. Fifteen seconds after dialling, the
display will switch from showing the number dialled to showing the duration of the call. The call duration will still be
retained in the display for a few seconds after the call has been ended.
4.6

Switching the handset on and off

You can switch off the handset by pressing and holding the
battery power will be used. It will not be possible to receive calls.
Press the button once to switch the handset on again. The display will show the message BASE 1 and the
handset will switch on again after a short time. The handset will switch itself on automatically as soon as you replace it
on the base station.
4.7

Range information

The range of the handset is ca. 50 metres in closed rooms and ca. 300 metres outdoors. When there is a good
contact with the base station, the
If you are too far away from the base station, the
move nearer to the base station once more, as otherwise the call will be interrupted. These warning tones can be
switched off as described in Chapter 7.8.
68
- Operation -
button for a long time.
and the required connection will be made.
. The display will now show the first number stored in alphabetical order.
and the telephone number displayed will be automatically dialled.
symbol will come on in the display.
symbol will flash and you will hear warning tones. In this case,
. On entering the digits of your required
and buttons.
button. If the handset is switched off, no
button.