Making Calls; Dialling Stored Numbers From The Phone Book; Call Duration Display; Range Information - switel D6017 Mode D'emploi

4.3

Making calls

1. Enter the required telephone number with a maximum of 25 digits using the number pad.
As the display is only capable of showing 12 digits, in the case of longer phone numbers
only the last 12 digits are displayed.
Note: If you have entered a number incorrectly, you can delete the number by repeatedly
INT
pressing the
for a long time.
2. Press the call button
Note: You can also get a dialling tone by first pressing the call button
digits of your required phone number, your telephone will dial the number directly. With this
method of making a call, it is not possible to correct individual digits in the number in the manner
described above.
4.4

Dialling stored numbers from the phone book

After you have stored a few phone numbers, you can call these up very quickly and easily.
1. Press the phone book button
alphabetical order.
2. You can now select all of the stored numbers with the
To choose a phone number directly alphabetically, press the appropriate letter.
3. Now press the call button
dialled.
4.5

Call duration display

The call duration in minutes and seconds is shown in the display during a call. Fifteen seconds
after dialling, the display will switch from showing the number dialled to showing the duration of
the call. The call duration will still be retained in the display for a few seconds after the call has
been ended.
4.6

Range information

The range of the handset is ca. 50 metres in closed rooms and ca. 300 metres outdoors. When
there is a good contact with the base station, the
If you are too far away from the base station, the
tones. In this case, move nearer to the base station once more, as otherwise the call will be
interrupted. These warning tones can be switched off as described in Chapter 0.
88
button. The number is completely deleted by pressing the
and the required connection will be made.
and the telephone number displayed will be automatically
- Operation -
. The display will now show the first number stored in
symbol will come on in the display.
symbol will flash and you will hear warning
. On entering the
buttons.
and
INT
button