Pentair PKS-B 800 Série Mode D'emploi page 8

ENGLISH
You have purchased a product made by Pentair Jung Pum-
pen and with it, therefore, also excellent quality and service.
Secure this service by carrying out the installation works
in accordance with the instructions, so that our product
can perform its task to your complete satisfaction. Please
remember that damage caused by incorrect installation or
handling will adversely affect the guarantee.
This appliance can be used by children aged 8 years or over
and by persons with limited physical, sensory or intellectual
capabilities, or with limited experience and knowledge, pro-
vided that they are supervised or have been instructed in
the safe use of the appliance and are aware of the dangers
involved. Children must not be allowed to play with the ap-
pliance. Cleaning and user maintenance must not be carried
out by children unless they are supervised.
Damage prevention in case of failure
Like any other electrical device, this product may fail
due to a lack of mains voltage or a technical defect.
If damage (including consequential damage) can occur
as a result of product failure, the following precautions
can be taken at your discretion:
• Installation of a water level dependent (under circum-
stances, mains-independent) alarm system, so that
the alarm can be heard before damage occurs.
• Inspection of the collecting tank/chamber for tight-
ness up to the top edge before – or at the latest, during
– installation or operation of the product.
• Installation of backflow protection for drainage units
that can be damaged by wastewater leakage upon prod-
uct failure.
• Installation of a further product that can compensate
in case of failure of the other product (e.g. duplex unit).
• Installation of an emergency power generator.
As these precautions serve to prevent or minimise con-
sequential damage upon product failure, they are to be
strictly observed as the manufacturer' s guideline – in
line with the standard DIN EN specifications as state of
the art – when using the product (Higher Regional Court
Frankfurt/Main, Ref.: 2 U 205/11, 06/15/2012).
SAFETY INSTRUCTIONS
This instruction manual contains essential information
that must be observed during installation, operation and
servicing. It is therefore important that the installer and
the responsible technician/operator read this instruc-
tion manual before the equipment is installed and put
into operation. The manual must always be available at
the location where the pump or the plant is installed.
Failure to observe the safety instructions can lead to the
loss of all indemnity.
In this instruction manual, safety information is distinct-
ly labelled with particular symbols. Disregarding this in-
8
formation can be dangerous.
General danger to people
Warning of electrical voltage
NOTICE! Danger to equipment and operation NOTICE!
Qualification and training of personnel
All personnel involved with the operation, servicing, in-
spection and installation of the equipment must be sui-
tably qualified for this work and must have studied the
instruction manual in depth to ensure that they are suf-
ficiently conversant with its contents. The supervision,
competence and areas of responsibility of the personnel
must be precisely regulated by the operator. If the per-
sonnel do not have the necessary skills, they must be in-
structed and trained accordingly.
Safety-conscious working
The safety instructions in this instruction manual, the
existing national regulations regarding accident pre-
vention, and any internal working, operating and safety
regulations must be adhered to.
Safety instructions for the operator/user
All legal regulations, local directives and safety regula-
tions must be adhered to.
The possibility of danger due to electrical energy must
be prevented.
Leakages of dangerous (e.g. explosive, toxic, hot) sub-
stances must be discharged such that no danger to peo-
ple or the environment occurs. Legal regulations must
be observed.
Safety instructions for installation, inspection and
maintenance works
As a basic principle, works may only be carried out to
the equipment when it is shut down. Pumps or plant that
convey harmful substances must be decontaminated.
All safety and protection components must be re-fitted
and/or made operational immediately after the works
have been completed. Their effectiveness must be
checked before restarting, taking into account the cur-
rent regulations and stipulations.
Unauthorised modifications, manufacture of spare
parts
The equipment may only be modified or altered in agree-
ment with the manufacturer. The use of original spare
parts and accessories approved by the manufacturer
is important for safety reasons. The use of other parts
can result in liability for consequential damage being re-
scinded.
Unauthorised operating methods
The operational safety of the supplied equipment is only
guaranteed if the equipment is used for its intended
purpose. The limiting values given in the "Technical Data"
section may not be exceeded under any circumstances.