Installation And Connection - Bartscher 610.835 Mode D'emploi

•
Do not use metallic pots, pans or covers. Metal may lead to sparks in the cooking
chamber. Use only dishes resistant to high temperatures, designed for use in
microwave ovens (see sec. 5.4). Risk of fire!
•
During the heating of liquids in the microwave oven it is possible that the liquid may
reach boiling temperature without externally visible bubbling. For this reason, special
care must be taken when handling the container. Even a light bump, e.g. when
removing the liquid from the device, may lead to spillage. Risk of burns!
•
For that reason avoid using tall, narrow containers with a thin neck.
•
Place a spoon (only in exceptional cases use a metallic one) or glass stirrer in the
beverage, then place the dish in the center of the rotating tray. Stir the liquid prior to
heating and after half the heating time has elapsed. After heating: wait for a moment,
carefully stir the liquid, then remove from the cooking chamber.
•
As food prepared in the microwave is heated unevenly, the contents of children's
bottles must be mixed thoroughly - optimally by shaking – then, before giving
the bottle to the child, check the temperature of the food. Risk of burns!
Prior to heating food remove the bottle cap and nipple!

5.2 Installation and connection

•
Unpack the device and remove all packing material.
•
Place the device on a flat, stable surface which can support the weight of a
microwave oven, as well as heavy dishes and food products.
•
Do not place the device near flammable materials avoid high temperatures, moisture
and high humidity.
•
Never place the device on a flammable surface (e.g. tablecloth, rug, etc.).
•
To ensure proper functioning, the device must have sufficient ventilation. For this
reason, it is necessary to maintain the following safe distances:
- above the device: 20 cm
- at rear of device: 10 cm
- at sides of device: 5 cm.
•
Never block the ventilation ducts!
•
The device must remain a minimum distance of 2 m from radios, televisions, and
other such electronics in order to avoid interference with the signal reception.
•
The wall socket circuitry must be secured to a minimum of 16A. Connect the device
directly to a wall-mounted socket; do not use extension cords or power strips.
•
Position the device so that the plug is readily accessible and if necessary can be
easily removed from its socket.
- 41 -