Assembly; Assembling The Curved Handle; Installing The Grass Catcher; Operation - Grizzly ERM 1438 G Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
GB
16 Release button (not visible)
17 Power inlet
18 Power cable

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Assembling the Curved Handle

Tip up bottom bar:
1. Tip up the bottom bar (4) to your
favourite angular position.
2. Lock the bottom clamping levers
(6) by pushing them towards the
bar (4). Clamping levers to be
tightened and contacting the bar
such that they clamp at average
force.
Otherwise you may have to
tighten (turn clockwise) or loos-
en them (turn anticlockwise).
Attach cable strain relief:
Push the cable strain relief (14)
over the curved handle (1).
Install curved handle:
1. Use the screws and washers from
the package as well as the top
clamping levers (3) to mount the
curved handle (1) on the right and
left ends of the bottom bar (4).
Three positions are possible.
2. Turn the clamping levers (3)
clockwise.
3. Lock the clamping levers (3)
by pushing them towards the
bar (4). Clamping levers to be
tightened and contacting the bar
such that they clamp at average
force.
72
Otherwise you may have to
tighten (turn clockwise) or loos-
en them (turn anticlockwise).
Clip on the cable hook:
Clip on the cable hooks (
to the bottom bar to fasten the
connection cable (

Installing the grass catcher

Assemble the grass catcher:

Clip the rubber lip of the grass
catcher net (19) into the hard
plastic tray of the grass catcher
(9).
Insert the linkage tubes (19) into
the grass catcher net (20). Make
sure to fully insert the tubes (see
ill. detail).
The tube bows fit into the
groove (21) at the bottom of the
grass catcher
ƒ
Pull the plastic straps (22) over
the linkage tubes (20).
Use the screws and washers
(23) from the package to mount
the linkage tubes (20).

Operation

Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
Mounting / removing the grass
catcher
1. Lift the collision guard (5).
2. Place the grass catcher (7) on the
mounting bracket (23) provided at
the back of the lawn mower.
3. Lower the collision guard (5)
, 13)
, 15).

Publicité

Table des Matières
loading

Table des Matières