gigamedia GGM DVR41TO Mode D'emploi page 70

4.2.7.3. Input device
EN
If SYSTEM- ID color is Yellow, the system accepts remote-controller key input.
If SYSTEM- ID and Active-ID are not matching, SYSTEM- ID color will be Red and the system does not accept remote-controller key input.(No beep)
How to match SYSTEM- ID by remote controller
(1) Press DVR-ID button of remote controller.(You can hear short double-beep.)
(2) Then, press desired System-ID by using 2 numeric button. (E.g. 02 or 03 or 01)
4.2.7.4. User
• NETWORK – Checking this box makes users access or control DVR in NETWORK function.
• MONITOR – All users can monitor the current screens.
• TIME OUT – When this is set to ON, LOGIN window will re-appear after entered time from any signal input. If you want to log out, you need to go to MENU and
select LOG OUT like right picture.
4.2.7.5. Upgrade
If you open this menu, you can see the current firmware version of DVR.
If you would like to upgrade firmware of DVR, please follow the below steps.
If you click upgrade icon, the small upgrade window will pop up
There are two ways; USB UPGRADE, NETWORK UPGRADE.
Note : There is two methods to upgrade the DVR system.
- USB UPDATE - Upgrade the DVR system by using USB memory stick.
- NETWORK UPDATE - Upgrade the DVR system through Internet.
70
• SYSTEM-ID – Input the number that you want to register in this DVR.
• KEYBOARD – DVR system can be connected with control keyboard.
• KEY-TONE – Beep whenever button is pressed if ON is selected.
How to set up System-ID status
System-ID status shows whether the system will accept key from remote-controller or not.
SYSTEM-ID is used when user operates several systems with one remote controller.
SYSTEM- ID will be displayed when SYSTEM- ID is other than 0(zero).
By using DVR-ID button of remote controller, Remote controller can be matched with SYSTEM- ID, or
if SYSTEM- ID is 00, system-ID is not displayed and system accept key from remote controller.
R : 01
Not working
Working
R : 02
R : 03
Not working
There are two fixed users such as ADMIN and NETUSER. Their values of authority are already
set and unchangeable like the below picture. Additionally, you can create Max. 4 more authori-
zed accounts, and you also give limited authority to control DVR system by checking each box.
• USER – There are two unchangeable user IDs (ADMIN, NETUSER), and additionally you can
add four additional USERs by your own.
• PASSWORD – Only passwords for ADMIN and NETUSER are set to '0000'. When you create a new
account, make sure that you have to enter new PASSWORD. And don't forget the Password.
• SETUP – Only by checking this box, accounts can be allowed to enter SETUP MENU.
• REC. F – Checking this box allows users to control and change values about RECORD, PLAY-
BACK, and BACKUP functions.
ACTIVE ID : 02
www.gigamedia.net