gigamedia GGM DVR41TO Mode D'emploi page 53

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.4.2. Quad screen mode
• To see quad screen mode, press
• Whenever pressing button, screens will go to next quad screens.
• If you press a numeric key of remote controller which is inside current display range, selected channel is displayed as full screen mode.
• If you press a numeric key of remote controller which is outside of current display range, the quad containing selected numeric will be displayed.
E.g. you press 6 while current screen shows CH1~Ch4, CH5~CH8 will be displayed.
1 CAM01
3 CAM03
3.4.3. 9ch display mode – 8 channel DVR / 16 channel DVR : Only for 8/16 Channel
• To see cameras by 9ch mode, press
* In case of 16channel DVR
• If you press a numeric key of remote controller which is inside current display range, selected channel is displayed as full screen mode.
• If you press a numeric key of remote controller which is outside of current display range, the nine screens containing selected numeric will be displayed.
3.4.4. 16ch display mode – 16channel DVR : Only for 16 channel
• To see camera by 16ch mode, press
3.4.5. POP mode : Only for 8/16 Channel
• Press POP button to enlarge specific camera with 7 other cameras.
• Whenever pressing POP button, the biggest screen will change.
3.4.6. OSD Hide or Show
• Press OSD button of remote controller to appear or disappear OSD.
When there is no command into DVR, Status bar will be hidden.
When you press any button or click by mouse, Status bar will be shown again.
www.gigamedia.net
button.
2 CAM02
4 CAM04
button.
button.
OSD button
You can set to hide Status bar only at SETUP menu
[SETUP > DISPLAY > OSD]
6
5 CAM05
7 CAM07
6 CAM06
8 CAM08
53
EN

Publicité

Chapitres

Table des Matières
loading

Table des Matières