gigamedia GGM DVR41TO Mode D'emploi page 77

5.4.2. DVR list
To register DVR in CMS, please follow the below steps;
After you input PW in Login window, you can see operating CMS program.
You can make DVR list to connect and all camera of the DVR will be displayed in the connection.
1) Please select ALL and then click add folder ICON.
2) Please input Group name, then the group name will be created as tree of ALL.
3) Please select the group name and then click add folder ICON again, and then the Site window will pop up.
4) Please input each value in items.
Site Name : Please input DVR site name you like to write down.
Address : Please input the same IP address as that of DVR you set up in DVR. [see user's manual page 67]
User ID : Please input the same user name in DVR [see manual page 70]
Password : Please input the same password as that of DVR [see manual page 70]
Port Number : Please select the same port number in that of DVR[see manual page 68]
The default value is netuser in User ID, and 0000 in password. The Network status in 4.2.7.4. USER (page 70) should be checked for users to see DVR with CMS.
5) Please click OK ICON, and then the status of DVR you selected will be shown in small window.
6) Please click connection ICON, the DVR will be connected.
5.4.3. Pre list
www.gigamedia.net
You can make camera list to display from some DVRs. Then, you can save the camera list and
load. DVR should be registered first at DVR LIST
EN
77