Record - gigamedia GGM DVR41TO Mode D'emploi

4.2.2.5. Scan point
• CAMERA – Select a specific camera to set up SCAN points.
EN
• LIST – Create another SCAN list
• PRESET – Select desired preset position.
• CLEAR ALL – Cancel all saved scan points.
Note : In SCAN point menu, you can set up PTZ tour route (SCAN-LIST) using saved PRESET position.
You can create 4 scan lists for each camera. You should setup PTZ protocol and PRESET Positions before setting Scan-List.
You can create Max. 4 SCAN lists.
4.2.2.6. Color
4.2.2.7. Position

4.2.3. Record

62
E.g. In this case,
Camera 1 will move to saved position as follows :
PTZ04 > 3 sec > PTZ12 > 3 se > PTZ04 > 3 sec > PTZ12 > 3 secvPTZ04 > ...
• CAMERA – Select camera to set up color.
• BRIGHT – Adjust bright of camera.
• CONTRAST – Adjust contrast of camera.
• COLOR/SATURATION – Adjust saturation of camera.
• COLOR/HUE – Adjust hue of camera.
• DEFAULT – Set all values to factory default.
• CAMERA – Select camera to adjust position.
• LEFT/RIGHT – Move camera position to LEFT or RIGHT in screen.
• DEFAULT – Set all values to factory default.
When you click Record Icon, Record menu is divided into 4 sub-menus :
PARAMETER, SCHEDULE, WATERMARK, AND MISC
www.gigamedia.net