Prior To First Start-Up - Sonoswiss DURA T 12/H Mode D'emploi

4.8 Operating controls of the ultrasonic unit
A B C E F
D
URA
High Quality Ultrasonic Systems High Quality Ultrasonic Systems
28 khz 80 khz
Off
High Quality Ultrasonic Systems 1
15
0
30
3
35
80
Frequency
13
5
40
75
11 45
7 70
9
50
65
Time (min) 60 55
Temperature Heat Power Level
D
46 | EN
A
Set cleaning time, possible settings for
short-term operation: 1; 3; 5; 7; 9; 11; 13; 15
minutes (automatic shut-off).
Permanent setting ∞ for continuous operation.
In this case, the shut-off must be performed
manually.
G H
B
Temperature range switch for activating
heating control. Temperature range (settings
range) from 30°C - 80°C.
C
LED indicator for heating is lit yellow
if in the ultrasonic cleaning tank
the heating element has been activated
by the temperature range switch
D
Sonic Degas
100
On/off LED switch for switching
90
10 the unit on and off. After actuating the switch,
80
a blue LED lights up.
20
70
30 Function
60 E
40
50
LED indicator for liquid level, level switch for
Gen. power
bath liquid. Switches off the device if the fill
level drops below the minimum value. LED
lights up red.
F
Frequency selector switch allows the
system operator to select between
28 kHz or 80 kHz
G
Power setting switch
from 10 – 100%
H
Ultrasonic function switch allows the
switch-over between Sonic and Degas
functions

5 PRIOR TO FIRST START-UP

5.1 Unpacking and setting up
Packaging
Keep the packaging for customer service purposes, if possible. If disposing of the packaging, observe the applicable disposal regulations.
You may return the packaging to the manufacturer or the supplier.
Check for transport damage
Inspect the unit before the first start-up for possible transport damage. In the event of obvious damage, do not start up the unit.
Please contact your supplier and the carrier.
Set-up surface
For operation, set up the unit on a stable, level, dry surface that is resistant to the cleaning liquid.
Ensure sufficient ventilation at the set-up location of the unit!
DANGER
Risk of electric shock from ingress of liquid!
Protect the unit against ingress of moisture.
The inside of this unit is protected against dripping liquids on the outside.
Nevertheless, keep the set-up surface and the housing dry to prevent electrical accidents and damage to the unit.
Environmental conditions
The following prerequisites must be met for the safe operation of this unit:
• Permissible ambient temperature during operation: +10°C to +40 °C
• Permissible relative humidity during operation: max. 80%
EN | 47