Funkwerk elmeg ICT8800 Mode D'emploi page 18

English
g
You are conducting a call. A second
party calls you.
Accepting a waiting call
g
You are conducting a call. You will hear
the call waiting signal.
Refusing a waiting call
g
You are conducting a call.
A second party calls you.
You hear the call waiting signal.
R0
Dial the code for refusing the waiting call. The caller can be switched to the waiting queue, or the call is established and the
caller will hear the busy signal.
Transferring the existing call using analog telephones
If you hear the call waiting signal while engaged in a call , you can accept that call and transfer the existing one.
g
You are conducting a call. You will
hear the call waiting signal.
Transferring calls with / without advance notice
Transferring calls internally without advance notice
You can transfer calls when you dial the number of the internal party and then hang up the handset. The internal party is then called and can
take the call when he/she lifts the handset.
g
You are conducting an external call.
R
Press the R key. You will hear the internal dial tone.
t
Dial the number of the internal party to whom you wish to transfer the call.
You hear the ringing tone in the handset.
The internal party will be called.
If you hear the busy signal press the R key again to retrieve the call that is on hold.
a
Replacethehandset. Theinternalparty willbecalled. Theparty beingcalledliftsupthehandsetandconductstheexternal
call. If the called party does not lift uphis/her handset he call willbereturned to your telephone after a timeinterval set du-
ring programming.
Transferring calls with advance notice
You wish to transfer an internal or external call to another internal party and speak with that party beforehand.
g
You are conducting an internal or external call. You wish to transfer the call to another party.
R
Press the R key. You will hear the internal dial tone.
If you hear the busy signal, press the R key again to retrieve the call.
t
Dial the number of the party you wish to reach.
You hear the ringing tone in the handset.
The internal party will be called.
The party being called lifts up the handset of his/her phone.
g
Conduct this internal call.
Tell your internal partner that you wish to transfer the call currently on hold to him/her.
14
R2
Dial this code You will be connected with the waiting party. Your first call is put on hold
(see »Enquiry call«). For further procedures refer also to »Broker's call«
a
Replace handset (your
first call is terminated)
R5
Dial this code Dial the number of the party you
wish to transfer the existing call to
g
or »Three-party conference call«
l
Your phone rings Lift up the handset of your phone. You
will be connected with the waiting party.
t
You will be connected with the waiting party
b
#
Terminate your input.