Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
elmeg ICT46
elmeg ICT88
elmeg ICT880
elmeg ICT880xt
elmeg ICT880-rack
elmeg ICT880xt-rack
*) 2x 8 UP0 requires a 75 W power supply
The functions described in these assembly instructions are based on the firmware status for the PABX systems valid at the time of printing.
Some functions may not be supported with older versions of the firmware.
Module installation
The modules have already been taken into account for the PABX system. If a module is installed prior to initial commissioning, the numbers
are automatically assigned to the connections.
Note that the external ISDN connection is not recognized automatically when the system is switched on. You must this up during configura-
tion.
The designations (0, 1 and 2) are likewise used in the configuration and operation of the PABX (for example, call forwarding). See page insi-
de view elmeg ICT on next page.
Unplug the 230 V AC plug. Disconnect the PABX from all analog, door terminal and ISDN connections. Attention! You may be elec-
trostatically charged. To ensure that you have no electrostatic charge, touch a conducting object connected to»ground« (e. g. water
pipe) before you open the PABX system.
Note regarding module installation
Remove any ferrite material from the flat cable when connecting the modules.
Attention! Use caution during removal, as the ferrite may break off, producing sharp edges. Place the ribbon cable with the ferrite
into the shipping bag for the module and then break up the ferrite by lightly hammering it. After that, you can carefully remove the
ribbon cable and dispose of the rest of the ferrite in the bag.
2
2
2
1
2
2
2
1/1*)
2
2
2
1/2 *)
2
2
2
1
2
2
2
1/2 *)
2
2
2
1
1 - Ferrite
2 - Flat cable
3 - Module
Number for each PABX
1
5
1
1
2
8
2
1
2
8
2
1
2
5
2
1
2
8
2
—-
2
5
2
—-
English
1
---
1
1
1
1
1
1
1
1
1
1
1
—-
—-
—-
1
1
1
1
1
—-
—-
—-
1
1
1
1
1
1
7
Publicité
Table des Matières
