Funkwerk elmeg ICT8800 Mode D'emploi page 16

English
Malicious caller ID (tracing)
g
Ongoing call, or caller hangs up
Attention: Only hang up the handset after you have entered the code for tracing the caller and hear the positive acknowledgement
signal.
Allocating project numbers
Assigning a project number for a call you initiate
b *50
Lift up handset
Project number for incoming external call to ISDN terminal device
You can use this feature at an ISDN terminal if your ISDN terminal device supports the function »Net direct« (Keypad) during an ongoing
call.
You are conducting a call and wish to register it for a project.
g *50
Conversation
Project number for an external call
You can use this feature at an analog or an ISDN terminal device if your ISDN terminal does not support the function »Net direct« (Keypad)
during an ongoing call.
You are conducting a call and wish to register it for a project.
g R *50
Conversation
Keypad function (»Net direct«)
b
Lift up handset
Sending a fax from a multi-function terminal
b
Lift up handset Enter code number for fax group 3
Direct dial-in (Hotline)
Making telephone calls with activated direct dial-in
b
Lift up handset
Entering and activating a direct call number (Hotline)
b *65
Lift up handset
12
*51
t
Enter project number ( max. 6-place)
t
Enter project number ( max. 6-place)
t
Enter project number ( max. 6-place)
0 (UK 9)
Dial line access digit
*773
t
Begin dialing within the configured time
t
MSN extension number (without line access digit)
q
Ack. signal
#
#
Ack. signal
#
* #
or
Initiate keypad function Enter codes
t
Dial external number
#
a
Replace handset.
q t
Ack. signal Dial number
q g
Continue call
q R g
Ack. signal Continue call
t a
Replace handset.
l
q a
Ack. signal Replace handset.