Ecler DP 300 Manuel Utilisateur page 52

Outputs
Clicking on an output tab, brings up the output configuration window. Please consider that in stereo link
configurations, outputs will appear as pairs, according to the link options:
From this window, output gain, limiter, source, delay, crossover filters and equalizers can be easily
configured. The meaning of these parameters is exactly the same as previously explained for the DP300
unit.
The crossover filters can be configured in exactly the same way as in the DP300 unit. Filter type
(Butterworth, Bessel, Linkwitz-Riley), filter slope and upper and lower cut-off frequencies can be
adjusted here.
The output equalizers can be set up in the same way as previously explained for the inputs. Always keep
in mind that the DSP imposes a limitation in the number of available filters. Refer to the "DSP resources"
section in this manual for further information.
52