Ecler DP 300 Manuel Utilisateur page 17

Owner Lock
Attention! Keep your password in a save location. The unit cannot be unlocked without this
password.
The "Owner Lock" locking mode is the second security level of the DP300 and operates in exactly the
same way as the "OEM Lock" mode, except the term Own is used instead of OEM and a different locking
symbol is shown. Both locking levels may be used simultaneously. The default password for "Owner
Lock" in the DP300 is USER.
6. MIDI Operation
The DP300 is specified to use MIDI commands. Several screens allow the adjustment of the MIDI
parameters to best suit your system set-up.
Besides this MIDI communication, the DP300 features a RS-323 port for serial connection to a PC. With
the dp:lab editing and control software provided with the processor, all adjustments and program
management can be easily performed remotely from the PC.
Choosing the MIDI Channel (1-16)
From this screen, the channel used to transmit and receive MIDI commands to and from a remote device
can be chosen. Select one channel between 1 and 16 by turning the encoder wheel or pressing the
◄ and ► keys.
Keep in mind that for a correct MIDI communication, both receiving and transmitting devices must be set
ot the same MIDI channel.
SETUP
Midi channel
Adjusting the MIDI mode
From this screen you can chose which type of information the DP300 can transmit via its MIDI OUT
socket. This will depend on the usage of the DP300 inside your system. Following MIDI modes are
available:
Off
-
Program (Prog)
-
Thru
-
Master
-
PCPort
-
Off
No type of MIDI messages are transmitted to the OUT port except "MIDI Sysex" (system exclusive)
messages.
SETUP
Midi Mode
1
Off
17