Ecler DP 300 Manuel Utilisateur page 12

2 x 3 way Mode
In this mode, 2 channels and 3 ways, the processor is configured as follows:
Outputs 1, 3 and 5 are connected to input channel CH1 (A).
-
Outputs 2, 4 and 6 are connected to input channel CH2 (B).
-
The default Delay link is set to OFF.
-
The stereo link is activated (ON).
-
The names assigned to each output are:
-
OUT 1 and OUT 2 – Low (Bass)
OUT 3 and OUT 4 – Mid
OUT 5 and OUT 6 – High (Treble)
3 x 2 way Mode (LCR 2 way)
In LCR 2 way mode (Left, Centre, Right), the processor is configured as follows:
Outputs 1 and 4 are connected to input channel CH1 (A).
-
Outputs 3 and 6 are connected to input channel CH2 (B).
-
Outputs 2 and 5 are connected to input SUM CH1(A)+CH2(B).
-
The default Delay link is set to OFF.
-
The stereo link is activated (ON).
-
The names assigned to each output are:
-
OUT 1 and OUT 3 – Low (Bass)
OUT 2 – C Low (Centre Bass)
OUT 4 and OUT 6 – High (Treble)
OUT 5 – C High (Centre Treble)
12