Ecler DP 300 Manuel Utilisateur page 15

- OEM Lock
Attention! Keep your password in a save location. The unit cannot be unlocked without this
password.
The OEM Lock level lets you lock all or some edited parameters in a program. The locking information
will be saved to the program itself.
Following screen appears:
SETUP
OEM Lock
If the ► key is pressed or the encoder wheel is turned right, a new screen appears asking for a
password.
OEM PASSWORD
-
The password should be introduced using the PREVIOUS and NEXT keys or the encoder wheel to
chose the character and the ◄ and ► keys to move the cursor left or right. The default password for the
DP300 is ECLER. If a wrong password is entered, an error message appears, and the initial OEM Lock
screen will reappear.
WARNING!
Password wrong
Once the password is introduced, press ENTER to confirm. Following message will appear briefly:
Lock Setup OEM
Enter when done
Then, the processor takes you to the "Lock all" screen automatically.
Lock Setup OEM
Lock all?
Once in "Lock All" mode, all processor parameters can be locked, so that later, individual parameters
can be unlocked selectively. In order to lock all parameters, turn the encoder wheel or press the
◄ and ► keys so that "Yes" appears. At this point, the processor will ask for the new password. You
can enter the same or a different one.
In case a previous locking needs to be unlocked, select "Yes" first and then "No".
In order not to execute this action, press SAVE/ENTER.
Once the program is locked, a rhombus appears at the lower right corner of the display, indicating the
Locked status.
Off
No
15