Ecler DP 300 Manuel Utilisateur page 13

Once the basic operation mode has been chosen, all relevant processor parameters can be modified in
order to match the desired specifications.
2. Crossover operation modes (Xover mode)
From this screen, the way in which the crossover filters of each output are modified can be configured.
Two operation modes are available: BOTH and EDGE.
SETUP
Xover Mode
or
SETUP
Xover Mode
If BOTH mode is chosen, modifying e.g. the upper cut-off frequency of the bass channel will drag the
lower cut-off frequency of the neighbouring filter, i.e. the mid filter. This crossover frequency needs not
be the same for both filters, as a certain "offset" can be put in between them. When e.g. the upper filter
slope of one channel configured as LOW way is changed in BOTH mode, the lower filter slope of the
adjacent channel configured as MID way is changed, too.
In EDGE mode, all crossover frequencies and slopes may be adjusted independently, without one way
affecting the adjacent one.
Both
Edge
13