Ecler DP 300 Manuel Utilisateur page 18

Program (Prog)
Allows the transmission of "Program Change" MIDI messages
SETUP
Midi Mode
Thru
The MIDI signal received at the MIDI IN port is replicated and transmitted to the MIDI OUT port.
SETUP
Midi Mode
Master
Allows the transmission of all parameter changes to another unit with the same MIDI channel. This
option is useful if two DP300 processors should operate in parallel with the same settings for stereo
applications.
SETUP
Midi Mode
PC Port
Allows the use of the RS-232 port of the DP300 for serial communication with a PC with the dp:lab
software (included with the DP300). This mode also permits the DP300 to be included in MIDI set-ups,
do system exclusive dumps and control other DP300 units.
SETUP
Midi Mode
MIDI System Exclusive information Dump
From this screen, information stored in the DP300 can be transmitted via a SysEx Dump to other DP300
units or to computer sequencers or software supporting this type of MIDI messages. Connect a MIDI
cable between the MIDI OUT of the transmitting device and the MIDI IN of the receiving device.
Following screen appears first:
SETUP
Midi Dump
If the ► key is pressed or the encoder wheel is turned right, following screen shows up:
Midi Dump?
Enter to confirm
18
Prog
Thru
Master
PCPort
No