Inputs - Ecler DP 300 Manuel Utilisateur

7. INPUTS

The DP300 features two physical inputs A (CH1), B (CH2) and the mix of both channels SUM A+B.
Depending on the selected operation mode, the inputs are grouped in different configurations.
In mono mode, they operate independently,
IN A(CH1)
IN B(CH2)
IN A + IN B
In both 2x3 way mode (2 channels, 3 ways) and in LCR 2 way mode (3x2 ways), following grouping is
valid:
IN A & IN B
IN SUM A+B
If the stereo link option should not be used (Stereo Link = Off) the inputs can be set up independently,
without being grouped.
For the inputs A(CH1) and B(CH2), Equalization (Eq) and Delay parameters can be adjusted, but for the
SUM A+B input, only Delay parameters can be modified.
You can switch from one input to the next by pressing the encoder wheel.
In any of the input configuration screens, parameters can be altered by turning the encoder wheel or by
pressing the ◄ and ► keys. To access the following parameter inside the current input configuration,
press NEXT or PREVIOUS.
Delay
The first configurable parameter for inputs A (CH1) and B (CH2) is the delay amount, which can be
adjusted up to a maximum of 635ms.
IN A
Delay
Equalization (Eq)
One or several equalizer blocks can be assigned to each input A (CH1) and B (CH2). Either Low or high
frequency shelving filters with 6 or 12 dB/oct slopes or fully parametric bell-type filters can be used. In
order to assign these EQ blocks, several parameters which determine the filter characteristics must be
adjusted first.
Following parameters appear on successive presses of the PREVIOUS key:
1. Equalizer type
2. Equalizer frequency
3. Equalizer gain
4. Equalizer width
1. Equalizer type
Pressing the PREVIOUS key brings up the first equalizer configuration screen. This screen refers to the
filter type selection:
IN A & IN B
Eq1S Bel
20
0.000ms
Sp8