Erreka VIVO-M101 Manuel De L'installateur page 51

Connection of photocells
P1 P2 P3 P4 P5 P6 P15 P14 P16 P7 P8 P11 P12 P22 P23
24Vac
ST1 FT1 ST2 FT2 FCA1 FCC1 STOP LOCK
Limit switch connection
P1 P2 P3 P4 P5 P6 P15 P14 P16 P7 P8 P11 P12 P22 P23
LOCK 24Vac
ST1 FT1 ST2 FT2 FCA1 FCC1 STOP
Operator connection with security device (VULCAN VUS)
P1 P2 P3 P4 P5 P6 P15 P14 P16 P7 P8 P11 P12 P22 P23
24Vac
ST1 FT1 ST2 FT2 FCA1 FCC1 STOP LOCK
G1 G2 G3
G7 G8 G9 G10
N L
POWER
Courtesy
Lamp.
MOTOR1 (G2-G1-COM)
Light
DIP2
DIP1
6 5 4 3 2 1
12/24V NC/NA TEST
P171G
G1 G2 G3
G7 G8 G9 G10
N L
POWER
Courtesy
Lamp.
MOTOR1 (G2-G1-COM)
Light
P171K
G1 G2 G3
G7 G8 G9 G10 N L
POWER
Courtesy
Lamp.
MOTOR1 (G2-G1-COM)
Light
P171L

We recommend installing interior and exterior
safety devices. If only one is installed, install the
exterior one. If a safety device is not installed,
make an electrical bridge in the corresponding
terminal of the control board.

Shown below is an example of the connections of a
FT02 photocell as an exterior safety device.
1 Connect the NC contacts of the photocell (1) in the
corresponding terminal of the control board.

Correctly programme the microswitches DIP1 and
DIP2 (see the photocell instructions).
2 The 24Vac terminal can be used to feed the
photocell.

The bridge (2) is necessary if an interior photocell is
not installed.

It is possible to connect limit switches in the opening
and closing stoppers of the gate, meaning the
operator will stop when they are activated.
O
If limit switches are not installed, make an electrical
bridge.
1 Connect the NC contacts of the opening limit switch
(FCA) in the corresponding connector.
2 Connect the NC contacts of the closing limit switch
(FCA) in the corresponding connector.

The VULCAN VUS operator is fitted with a patented
safety device which detects collisions during closing,
causing an immediate halt and reverse movement.
This safety device causes a halt in the event of
collision during opening.
1 Connect terminals 5 and 6 of the VUS operator
instead of FCA and place DIP12 in ON and DIP9 in
OFF.
2 Connect the NC contacts of the closing limit switch
(FCA) in the corresponding connector.

For more information on VULCAN VUS, see the
respective installation instructions manual.
INSTALLATION
Control board VIVO-M101(M)
47