Setting The Alarm Time - Renkforce 751514 Notice D'emploi

Code = acoustic display for first entry delay countdown
0 = acoustic signal is deactivated
1 = acoustic signal is activated (factory setting)
Time = The first entry delay period can be between 2 and 999 seconds long.
The factory setting is 60 seconds long.

10.10 Setting the alarm time

This menu item allows you to set the alarm time for the siren (clamp 8).
Memory location
(press the displayed
digits on the control
panel)
33
Code = With this code you control whether the alarm control centre emits a short acoustic signal when
arming/disarming the alarm. This is emitted by the attached siren (clamp 8).
Arming
Disarming =
0 = acoustic signal is deactivated (factory setting)
1 = acoustic signal is activated
Time = The acoustic signal period can be between 2 and 999 seconds long.
The factory setting is 300 seconds long.
Please observe the applicable legal and communal regulations!
In Germany an acoustic alarm signal may only sound for a maximum of 3 minutes. This time
period may, however, vary for specific communities or locations (e.g. health spas).
An example for programming to 180 seconds. This programming must be carried out as a minimum require-
ment, as the factory setting is an alarm time of 5 minutes (= 300 seconds).
Memory location
(press the displayed
digits on the control
panel)
33
Code
(enter the desired code on
the control panel)
0 or 1
= 2 signal tones
1 signal tone
Code
(enter the desired code on
the control panel)
0 or 1
Time
(enter the desired time in
seconds using the control
panel)
2 to 999
Time
(enter the desired time in
seconds using the control
panel)
180
Confirmation
(press the displayed
button on the control
panel)
#
Confirmation
(press the displayed
button on the control
panel)
#
115