Publicité
Les langues disponibles
Les langues disponibles
16.
Attach the bent rear frame tube to the push channel
using (2) 1/2" x 3-1/2" hex bolts, (4) 1/2" washers and
(2) 1/2" nylock nuts. Do not tighten yet.
17.
Remove the concrete block from under the engine
and place it underneath the the end of the rear frame
tube.
1/2" WASHER
1/2" NYLOCK
NUT
REAR FRAME TUBE
18.
Attach the support bracket to the mounting tubes using
(4) 5/16" x 1-3/4" hex bolts, (8) 5/16" washers and (4)
5/16" nylock nuts. Tighten.
5/16" NYLOCK NUT
5/16" WASHER
5/16" WASHER
5/16" x 1-3/4"
HEX BOLT
19.
20.
21.
22.
NOTe: Complete wheel assembly not shown for clarity.
1/2" x 3-1/2"
HEX BOLT
ANCHOR
BRACKET
FIGUre 15
NOTe: Before proceeding with next assembly step, make
sure the actuator is fully extended. Refer to step 11 on
page 6 in the Wiring Assembly Section.
23.
24.
FIGUre 16
9
Place the wheel assembly behind the engine mounting
base.
Fasten the bottom of the anchor brackets (part of
wheel assembly) to the outside of the mounting tubes
using (4) 1/2" x 2-1/4" hex bolts, (4) 1/2" washers (on
inside of mounting tube) and (4) 1/2" nylock nuts. Do
not tighten yet.
Fasten the tops of the anchor brackets to the engine
mounting base using (4) 5/16" x 1" hex bolts and (4)
5/16" nylock nuts. Do not tighten yet.
Tighten
all nuts and bolts assembled in steps 12-
14 and 18-21. Do not tighten the nuts and bolts
assembled in steps 15-16 at this time.
5/16" x 1"
HEX BOLT
5/16" NYLOCK
NUT
1/2" NYLOCK
NUT
Fasten top of actuator to wheel assembly using (1)
1/2" x 3" clevis pin, (2) .5" x 1" x .59" spacers and (1)
hairpin.
Fasten bottom of actuator to actuator bracket using (1)
1/2" x 2" clevis pin and (1) hair pin.
.5" x 1" x .59"
1/2" x 3"
SPACERS (2)
CLEVIS PIN
1/2" WASHER
1/2" x 2-1/4"
HEX BOLT
FIGUre 17
1/2" x 2"
CLEVIS PIN
HAIRPINS (2)
FIGUre 18
Publicité
