Publicité
Les langues disponibles
Les langues disponibles
42.
Slide the rear frame tube in or out of the push channel
to align it with the ATV hitch. Make sure the minimum
3"-4" clearance between the ATV and the snow thrower
is maintained.
43.
If the rear frame tube does not slide in or out enough
to align with the ATV hitch, move the bolts that fasten
the rear frame tube to the push channel to a different
set of holes. (Refer to figure 15). If alignment is still not
possible, move the bolts that fasten the push channel
to the mounting tubes to a different set of holes. (Refer
to figure 14).
44.
Attach the rear frame tube to the ATV hitch using a 3/4"
x 7-1/2" hex bolt, four (4) short spacers, a long spacer
and a 3/4" nylock nut. Place spacers above or below
the hitch as needed to maintain at least 1" clearance
with the bottom of the ATV and adequate clearance
with the ground. Tighten.
NOTe: Replace the bent rear frame tube with the straight
rear frame tube if the bent rear frame tube does not provide
adequate ground clearance and there is extra clearance
with the bottom of the ATV.
3/4" NYLOCK NUT
LONG SPACER (.81" x 1.25" x 1.5")
SHORT SPACER (.75" x 1.25" x .5")
ATV HITCH
3/4" x 7-1/2"
HEX BOLT
PUSH
CHANNEL
REAR FRAME TUBE
FIGUre 28
Tighten
45.
the nuts and bolts that fasten the push channel
to the mounting tubes, and the rear frame tube. Refer
to figures 14 and 15. Make sure the mounting tubes
stay centered with the ATV while tightening.
46.
Slide the guide bracket along the mounting tubes until
the front edge is a 1/4" in front of the front edge of the
stabilizer brackets as shown in figure 29. Tighten.
47.
Use a grease gun to apply general purpose grease
to the grease fittings in the wheel hubs and wheel
spindles. Apply until grease is forced out the ends of
the hubs and spindles.
48.
Connect the wiring from the tethered safety switch to
the bullet connector on the wire harness for the switch
on the control box.
49.
Reconnect the actuator to the handle bar switch that
was unplugged in step 11 on page 6.
CheCKLIST
Before you operate your snow thrower, please review
the following checklist to help ensure that you will
obtain the best performance from your snow thrower.
1.
All assembly instructions have been completed with all
bolts and nuts properly tightened.
2.
Check the discharge chute for proper rotation.
3.
Check operation of tilt control for upper chute.
4.
Verify that the wiring is correct for the actuator and that
the actuator will raise and lower the snow thrower.
5.
Check skid shoe adjustment. (Refer to the Service and
Adjustments section.
6.
Check that the tethered safety switch will shut off the
engine.
7.
Check that the wheel hubs and wheel spindles are full
of grease.
12
1/4"
FIGUre 29
Publicité
