Publicité
Les langues disponibles
Les langues disponibles
30.
Attach the control assembly's support tube to the
welded bracket below the discharge chute using (2)
5/16" x 1-1/4" carriage bolts and (2) 5/16" nylock nuts.
Do not tighten yet.
Tighten
31.
bolts assembled in steps 29 and 30.
5/16" NYLOCK NUTS
32.
Cut the nylon tie that holds the two chute crank brackets
together.
33.
Attach the chute crank brackets to the discharge
housing using (2) 5/16" x 1" carriage bolts, 5/16"
washers and 5/16" nylock nuts. Do not tighten yet.
34.
Adjust position of chute crank brackets so that spiral
does not rub bottom of discharge chute notches.
35.
Tighten
bolts and nuts assembled in step 33.
NOTe: Spiral not shown for clarity.
5/16" x 1"
CARRIAGE BOLT
5/16" WASHER
5/16" NYLOCK
NUT
36.
Attach the chute tilt control to the control assembly
using (2) 5/16" x 1-3/4" carriage bolts, (2) bowed
washers and (2) 5/16" nylock nuts.
37.
Using a nylon tie, secure the cables from the chute tilt
control to the support tube as shown in figure 25.
Note: Do not secure the chute tilt control cables in locations
other than the one shown.
5/16" x 1-1/4"
CARRIAGE BOLTS
FIGUre 23
FIGUre 24
SECURE CABLES HERE
CHUTE TILT
CONTROL
BOWED
WASHER
38.
Insert the wire harness into the large hole at the front
of the control box.
39.
Connect the wire harness to the switch.
40.
Using nylon ties, secure the wire harness and clutch
cable to the handle assembly to keep them from
interfering with moving parts.
41.
Roll the ATV up behind the snow thrower, keeping the
push channel centered between the stabilizer brackets.
Make sure the guide bracket will slide in between
the stabilizer brackets as shown in figure 27. Keep a
minimum clearance of 3"-4" between the front of the
ATV and the snow thrower.
NOTe: ATV not shown below for clarity.
STABILIZER BRACKETS
11
NYLON TIE
5/16" x 1-3/4"
CARRIAGE BOLT
5/16" NYLOCK
NUT
FIGUre 25
FIGUre 26
GUIDE BRACKET
FIGUre 27
Publicité
