Publicité
Les langues disponibles
Les langues disponibles
CONTrOLLING SNOw DISChArGe
•
To control the direction snow is thrown, the discharge
chute has 180 degrees of rotation. Turn the crank rod
clockwise to rotate the chute to the right. Turn the crank
rod counterclockwise to rotate the chute to the left.
•
To control the distance snow is thrown, the upper
section of the discharge chute pivots up and down.
Push forward on the chute tilt handle to pivot the chute
down, decreasing the distance snow is thrown. Pull
back on the handle to pivot the chute up, increasing
the distance snow is thrown.
rAISING AND LOwerING
•
To raise, use the handle bar switch to shorten the
actuator.
•
To lower, use the handle bar switch to lengthen the
actuator.
reMOVING SNOw
Snow removal conditions vary greatly from light fluffy
snowfall to wet heavy snow. Operating instructions must
be flexible to fit the conditions encountered. The operator
must adapt the ATV and snow thrower to depth of snow,
wind direction, temperature and surface conditions.
•
Before beginning operation, thoroughly inspect the
area of operation and remove all door mats, sleds,
boards, wires and other foreign objects.
CAUTION
thrower without attaching the clip of the
tethered safety switch to your clothing.
A riderless ATV with a running snow
thrower could cause serious injury to a
fallen operator or to others.
: Never operate the ATV snow
•
It is advisable to operate the ATV at a slow ground
speed for safe and efficient snow removal.
•
In deep, drifted or banked snow it will be necessary to
use slow ground speed. Drive forward into the snow
and allow the spiral auger to clear the snow. Repeat
this method until a path is cleared. On the second
pass, overlap the first enough to allow the snow
thrower to handle the snow without repeated stopping
and starting of forward motion.
•
In extremely deep snow, raise the snow thrower from
the ground to remove the top layer and drive forward
only until the ATVs front tires reach the uncleared
bottom layer of snow. Depress the ATV's clutch-brake
pedal and allow the spiral auger to clear the snow.
Reverse the ATV and lower the snow thrower to the
ground. Drive the ATV forward until the snow again
becomes too deep. Repeating this process into and
out of drifts will eventually clear even the deepest of
snow piles.
•
If the snow thrower becomes clogged with snow or
jammed with a foreign object, disengage the snow
thrower immediately and shut off the ATV and snow
thrower engines. Set the parking break on the ATV and
unclog the snow thrower with a wooden stick before
resuming operation.
DANGer
snow thrower before unclogging discharge
chute. Unclog using a wooden stick, not
your hands.
OPerATING TIPS
•
Discharge snow down wind whenever possible.
•
To help prevent snow from sticking to the snow thrower,
allow the snow thrower to reach outdoor temperature
before using it. A light coat of wax may also be applied
to the inside surface of the snow thrower housing and
discharge chute.
•
Use tire chains to improve traction if recommended by
your ATV owners manual.
•
Before the first snowfall, remove all stones, sticks and
other objects which could become hidden by the snow.
Permanent obstacles should be marked for visibility.
•
Overlap each pass slightly to assure complete snow
removal.
14
: Shut off engine and disengage
Publicité
