Publicité
Les langues disponibles
Les langues disponibles
STOrAGe reCOMMeNDATIONS
•
Clean the snow thrower thoroughly. Wash off any salt
deposit which may have dried on the thrower and
housing.
•
Any bare metal that has become exposed should be
painted or coated with a light oil to prevent rust.
•
Lubricate all pivot and wear areas.
•
Store in a dry area protected from weather.
reMOVAL INSTrUCTIONS
•
Lower the snow thrower to the ground.
•
Unplug the actuator.
•
Unplug the tethered safety switch from the wire harness
of the control box switch.
•
Remove the clevis pins from the strut mount assemblies
attached to the bottom of the ATV's front A arms and
remove the stabilizer assembly from the ATV. (Refer to
figure 9 on page 7.)
•
Remove the 3/4" x 7-1/2" hex bolt from the rear hitch of
the ATV to complete removal of the snow thrower.
PrOBLeM
Spiral augers don't turn
Clogged discharge chute
Snow thrower stalls
Front wheels slide instead of steering
Snow thrower rides up over snow
STOrAGe
PArTS TO reMOVe AT eND OF SeASON
•
TrOUBLeShOOTING
CAUSe
1. Drive belt too loose
2. Drive belt broken
3. Shear bolts are sheared.
1. ATV ground speed too fast
2. ATV throttle set too low
3. Snow too deep
4. Snow melts during contact with snow
thrower
1. Object jammed in spiral auger
2. Hard or heavy snow
1. Not enough traction at front wheels
2. Snow thrower wheels do not have
enough lubrication
1. ATV ground speed too fast
2. Bottom snow is icy or hard packed
17
Remove the A-arm brackets from the suspension
of the ATV, especially before using your ATV for off-
roading, trail riding or other activities hard on the
suspension. See the owners manual of your ATV for
more information.
1. Increase tension on drive belt
2. Replace drive belt
3. Replace shear bolts
1. Decrease ground speed
2. Increase to full throttle
3. Raise snow thrower
4. Allow snow thrower to cool to outdoor
temperature before using
1. Stop ATV and snow thrower engine,
disengage the snow thrower clutch
and clear the auger
2. Decrease ground speed
1. Increase scraper plate clearance by
lowering the skid shoes
2. Fill front grease zerks with grease
until a small amount comes out the
bottom
1. Decrease ground speed
2. Lower the skid shoes so that front of
skid shoe is lower than the rear
COrreCTION
Publicité
