Agri-Fab 45-0418 Manuel Du Propriétaire page 16

reMOVING The BeLT (Figures 32-35)
•
Remove the key and disconnect the spark plug wire
from the snow thrower.
• Remove the engine pulley cover, the drive cover and
the skid plate from the snow thrower.
•
Disengage the snow thrower clutch.
• Remove the belt from the top pulley.
• Engage the clutch.
•
Remove the belt from the bottom pulley.
•
Disengage the clutch.
• Lift up on the brake assembly and slip the belt between
the brake assembly and bottom pulley to remove the
belt from the snow thrower.
INSTALLING The BeLT
• Lift up on the brake assembly and slip the belt between
the bottom pulley and the brake assembly.
•
Engage the clutch.
• Install the belt around the bottom pulley.
• Disengage the clutch.
•
Install the belt around the top pulley.
•
Make sure the belt runs inside all of the belt keepers.
•
Replace the covers.
• Replace the key and reconnect the spark plug wire.
PULLEY COVER
FIGUre 32
16
DRIVE COVER
FIGUre 33
SKID PLATE
FIGUre 34
BRAKE ASSEMBLY
FIGUre 35