Güde GDS Série Traduction Du Mode D'emploi D'origine page 9

12. Avoid any unnatural body positions!
 Have a stable position and maintain your balance.
13. Be careful when servicing your tool!
 Keep your tools sharp and clean to make them easier and safer to work with.
 Comply with the maintenance instructions and instructions for replacing tools.
 Check the tool cable regularly and if it is damaged have it replaced by an authorised professional.
 Check the extension leads regularly and replace them if damaged.
 Keep all handles dry, oil and fat free.
14. Unplug from the mains!
 If you are not using the tool and before any maintenance work or replacement of, for example, the rotary saw, unplug it.
15. Do not leave any adjustable wrenches or spanners in the tool!
 Before start-up, check that you have not left any spanners or adjustable wrenches in the tool!
16. Prevent incidental start-up!
 Make sure that the switch is switched off before plugging the tool in.
17. Extension leads when outdoors:
 When outdoors use only extension leads which have been approved for this use and they are labelled accordingly.
18. Be careful!
 Be careful of what you are doing. Be sensible when working. Do not use the tool if tired.
19. Check the tool for any incidental damage!
 Before any further use, a fault free and prescribed function of safety devices or slightly damaged parts must be carefully
checked.
 Check if the rotating parts work fault free and do not seize, check for damaged parts. All parts must be assembled correctly
and must comply with the given conditions to secure a fault free operation of your tool.
Damaged safety devices and parts must be professionally repaired or replaced by an authorised professional shop unless

stated otherwise in the instruction manual.
 Use a customer service shop to replace any damaged switches.
 Do not use any tool if the on and off switch does not work.
20. CAUTION!
Using different extension devices and accessories may cause an accident.

21. Let a professional electrician repair your tool!
 This tool complies with relevant safety provisions. Repairs can be carried out only by a professional electrician using original
spare parts; otherwise the user might suffer an accident.
Additional safety instructions for the use of dual grinders and for wet and dry grinding
Grinding wheels can reach high rotations when in use. Please comply with the following instructions.
Never work without your safety glasses.
Make sure children are not able to switch the grinder on.
Regularly check secure positions of all screws.
Using the grinder without protective covers is inadmissible.
The anti-spark safety holder and tool holder must be occasionally adjusted.
Use only faultless grinding wheels.
Only grinding wheels showing information about the manufacturer, the type of coupling, dimensions and admissible rotations can be
used.
Grinding wheels should be stored at dry places with constant temperatures if possible.
To fasten the grinding wheel you should use only the attachment flanges which are a part of the delivery.
To fasten the grinding wheel, use only the attachment flanges of the same size and shape. Washers between the flange and grinding
wheel must be elastic, made for example from rubber, soft underlay etc.
No additional drilling of the attachment area of grinding wheels is allowed.
The wet/dry grinding wheel is a combined tool for rough and fine grinding. The tool has one wheel for dry grinding and one for wet
grinding. Please make sure that only the dry grinding disc is used for rough grinding. Fine grinding is done using the wet grinding wheel
whilst it is sufficient to exert only a slight pressure when grinding the work-piece.
Marking:
Product safety:
Product corresponds to
appropriate standards of
the European Union
9