Güde GDS Série Traduction Du Mode D'emploi D'origine page 11

Operator requirements
The operator must carefully read the Operating Instructions before using the appliance.
Qualification
No special qualification is necessary to use the appliance apart from detailed instructions by an expert.
Minimum age
The appliance may only be operated by persons over 18 years of age who have been instructed in handling and operating the appliance.
Young people between 16 and 18 years of age may only work with the appliance when supervised by an adult.
An exception includes youngsters operating the appliance within their professional education to achieve necessary skills under trainer's
supervision.
Training
Using the appliance only requires appropriate instructions by an expert or reading the Operating Instructions. No special training
necessary.
Transport and storing
The appliance must unconditionally be secured against falling or turning down during transport.
When storing, it is necessary that the appliance is put to a dry place, inaccessible to children and unauthorised
persons. Clean the appliance thoroughly before longer putting out of operation.
Network connection
Make sure that the switch is in the „0" position before plugging the tool in.
Grinder installation
The grinder should be fixed permanently at a suitable place. To attach the grinder to a hard and flat surface, there are four drilled holes
on the grinder. The tool support should be approximately at the height of your elbow.
Assembly of the anti-spark safety shields (Pic. 2)
Because of packing reasons, safety glass and anti-spark safety holder are packaged loosely and must be attached to the tool. The
following picture shows the assembly on the left side of the grinder. The right hand side assembly is a mirror reflection of the below.
1. Safety metal for further adjustments
2. Hexagonal screw
3. Washer
4. Self-blocking nut
5. Anti spark safety glass
6. Hexagonal screw
7. Elastic washer
8. Self-blocking nut
Adjusting the tool support and protective metal shield for additional adjustments (Pic. 3)
The tool support and protective metal shield for additional adjustment must be adjusted in such a way that the gap between the grinding
wheel and the tool support is not bigger than 3 mm, in other words the gap between the grinding wheel and protective metal for
additional adjustment is 5 mm.
1. Grinding wheel
2. Tool support
3. Protective metal shield for further adjustments
Grinding wheels
When replacing grinding wheels you must be careful to select a grinding wheel which is intended for your tool. This means that the
diameter of the attachment opening, the outside diameter and the thickness of the wheel must correspond. Please comply with all the
data on the tool performance label. When buying grinding wheels be careful to buy wheels with control numbers.
Wet grinding wheel (GNS 200/150 #40350)
The wet grinding wheel is suitable mostly for sharpening knives, chisels and tools for carpenters. When using a natural grinding stone
(sandstone) it is important to ensure that after the use all water is released from the tank otherwise the grinding stone will get loose, in
other words it will become unbalanced.
Sanding belt (only for GDS 150 K)
Abb. 4: 1 Adjusting button for the sanding belt guide
2 Sanding belt tension screw
3 Side cover
4 Sanding belt (50 x 686 mm)
11