Menu "User Settings - Mennekes AMTRON Xtra Guide D'installation

Energy Management Configuration
VALUE Description
Energy Manager Selection: log when using an
Protocol Energy Manager
„ Simple Energy Management
„ Energy Control Interface (ECI)

6.4.3 Menu "User Settings"

The menu "User Settings" can be used to make customer-
specific settings.
Wallbox Configuration
VALUE Description
AMTRON Input: Setting the limit of the maximum
Customer available charging current in A.
Current
Limitation
AMTRON Input: Device name.
Wallbox Name The device name is displayed in the
MENNEKES Charge APP and the ser-
vice interface.
Enable RFID  RFID card reader activated
Authorisation  RFID card reader deactivated
Power Fail  Charging will continue after a
Continue power failure
 Charging stops after a power fail-
ure
Autostart  The charging process starts auto-
Charging matically when connected to a
vehicle
 The charging process must be
started manually when connected
to a vehicle
This setting is not taken into
account if the RFID card reader
is activated.
Enable Stop  Stop button activated
Button  Stop button disabled
Color Schema Input: colour scheme at the LED infor-
mation field
Protocol (SEMP)
Enable RFID  Acoustic feedback of the RFID card
Beep reader activated
 Acoustic feedback of the RFID card
reader deactivated
Enable WLAN  WLAN module activated
Communication  WLAN module deactivated
AMTRON Selection: Operating mode of the
Operation Mode device
The submenu "Wallbox Date and Time Configuration" can
be used to set the date and the time.
„ The data of the Internet browser is accepted in
"Alignment with Browser Time".
„ In "Manual Configuration" the data must be entered
manually.
EN
23