Mennekes AMTRON Xtra Guide D'installation page 60

Electro Vehicle Data
Only configurable if no RFID card reader is activated /
present or the operating mode "SCU" is active.
Otherwise, the function can be set in the "Whitelist"
menu.
VALUE Description
No. of Vehicle Selection: Number of phases with which
Phases the vehicle charges
Minimum Selection: Minimum charging current
Current per per phase, which the vehicle needs for
Phase charging
Maximum Selection: Maximum charging current
Current per per phase, which the vehicle needs for
Phase charging
EV Wake-Up  Wake-up function activated
 Wake-up function deactivated
If the wake-up function is activated, older
vehicles can be switched from standby
mode to continue charging.
Some vehicles may respond
incorrectly to the wake-up signal.
MENNEKES it is not liable for the
correct reaction on the vehicle
side.
24
Integration into the home network via LAN
Ethernet Settings
VALUE Description
Use Static IP  Use static IP address
Address  Do not use static IP address
Static IP Address Input: Static IP address
Static Netmask Input: static network address
Static Gateway Input: IP address of the router
Address
The following data is displayed in the submenu "Ethernet
Status":
„ Ethernet IP Address
„ Ethernet Subnet Mask
„ Ethernet Gateway IP Address
„ Source of Ethernet IP Address
„ Ethernet MAC Address
Network connection through access point
WLAN Access Point Mode Settings
Value Description
Network Name / Input: Network name of the WLAN that
SSID the device makes available
Channel Selection: WLAN channel during the
operation of the device as an access
point
Security Mode Selection: WLAN encryption.
Country of Selection: Country in which the device
Operation is operated