Table des Matières
Publicité
Dépose du cadre en verre et d'installation
Attention: L'appareil doit être complètement refroidi avant de retirer le cadre en verre.
Attention: Ne pas frapper ou claquer le cadre de verre.
Attention: Ne pas utiliser l'appareil si la vitre est retirée, fissurée ou cassée. Le remplacement de
la vitre devra être effectué par un technicien de service certifié ou qualifié.
Based upon the face being used, either:
a
(a) swing the access door down and remove the top grill,
(b) remove the face (unscrew or lift off - see the instructions included with the face for details).
Open the six latches holding the glass frame in place (start with the bottom three) - follow the
directions shown to the right.
Lift the glass frame up and
b
pull it forward to remove.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions above in reverse).
c) Lift the glass frame slightly and attach the lower latches.
NOTE: Make sure the glass frame is all the way in place - it should be flush with
the front of the fireplace when installed.
© Travis Industries
Installation
(for qualified installers only)
NOTE:
You may need to lift
the glass frame
while re-attaching.
Latch
Catch
(on glass frame)
4121004
Top of
Firebox
Glass
100-01299
39
Publicité
Table des Matières
