Retrait Du Cadre En Verre Et D'installation - Travis Industries GreenSmart 864 Manuel D'installation

Table des Matières

Publicité

38
Finalizing the Installation

Retrait du cadre en verre et d'installation

Attention: L'appareil doit être complètement refroidir avant de retirer le verre.
Attention: Ne pas frapper ou claquer le verre.
Based upon the face being used, either:
a
(a) swing the access door down and remove the top grill,
(b) remove the face (unscrew or lift off - see the instructions included with the face for details).
Open the six latches holding the glass frame in place (start with the bottom three) - follow the
directions shown to the right.
Lift the glass frame up and
b
pull it forward to remove.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions above in reverse).
c) Lift the glass frame slightly and attach the lower latches.
NOTE: Make sure the glass frame is all the way in place - it should be flush with
the front of the fireplace when installed.
© Travis Industries
(for qualified installers only)
NOTE:
You may need to lift
the glass frame
while re-attaching.
4090507
Top of
Firebox
Latch
Catch
(on glass frame)
Glass
100-01217_000

Publicité

Table des Matières
loading

Table des Matières