Dépose Du Cadre En Verre Et D'installation - Travis Industries 31 DVI Mode D'emploi

Masquer les pouces Voir aussi pour 31 DVI:
Table des Matières

Publicité

Dépose du cadre en verre et d'installation
Attention: L'appareil doit être complètement refroidir avant de retirer le verre.
Attention: Ne pas frapper ou claquer la vitre.
Open the four latches holding the glass
a
frame in place (start with the two below
the glass) - follow the directions shown
to the right.
Glass Frame
Lift the glass frame up
b
and pull it forward to
remove. NOTE:
You may need to lift the
glass frame while re-
attaching.
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions to the right in reverse).
c) Lift the glass frame slightly and attach the lower latches.
© Travis Industries
Finalizing the Installation
NOTE:
Replace the cove
covers for those faces
using them.
4120319
Top of
Firebox
Glass
Latch
Push in on
the latch.
Twist 1/4 turn.
The latch will then
disengage from the
latch bracket.
100-01235_000
23

Publicité

Table des Matières
loading

Table des Matières