EB TECHNOLOGY START-S11 Mode D'emploi page 51

START-S11
Memorization of the START times
7.3
It is possible to programm the working time separatelly. If limit switches are available or it is programmed the
obstacle detection, the control boards makes automatically a complete cycle.
!
This operation is possible only when the gate is closes.
If during a memorization of the working times,
will work a security contact, make this operation again.
1
r 01
2
3
P1
APPt
4
1
5
Opening time MOT1:
6
memorized
7
P1
Opening time MOT2:
8
memorized
9
1 2
Close the gate.
Bring to the function P1, P2 and P3
go to the function R01.
Press button P1
2
1
>
and the motor 1 starts opening .
The displays confi rm
that you are memorizing the working time.
2
Wait until the fi rst leaf is completelly open.
If the OLS1 is not installed press P1, otherwise if the OLS1 is
connected don't do nothing because the limit switch gives a drive
to the memorization.
In case the function S10 is activated go to the point no.13 of
2
1
>
the table, otherwise the second leaf opens.
If the OLS2 is not installed press P1, otherwise if the OLS2 is
connected don't do nothing because the limit switch gives a drive
to the memorization.
The pause time shold be set up manually with T11,
the standard value is 10 sec.
-23-
Technical manual