EB TECHNOLOGY START-S11 Mode D'emploi page 32

START-S11
1.4 Type of electrical wires
Depending on the installation, the type and number of devices installed, the number of cables needed can
vary. The table below shows the cables needed for a typical installation. The cables used in the installation
must be IEC 60335 compliant.
Power supply line

Motor cable (if not equipped)

Flashing signal

Electric lock

Antenna

key selector

Photocell receiver

Photocell transmitter

1.5 Type of installation
It is important to make an important risk analysis of the " MACHINE" and of the customers requirements in
order to decide how many products should be installed. All NOLOGO photocells dispose of a synchronisation
system which permit to avoid any interference between two couples of photocells (look the photocell's
instructions for details)
In the diagram, photocells "FOTO A" in opening they have no effect, while it provoque a complete inversion
during closing. "FOTO A2" is the serial connection of "FOTO A" or "ALT, FOTO B" is the photocell working
by closing and opening.
Installations for swing gates
Cable 3x1,5 mm
2
Cable 4 x 1,5 mm
2
Cable 2x1,5 mm
2
Cable 2x1,5 mm
2
Shielded cable type RG58
Cable 3x0,5 o 0,75 mm
Cable 4x0,5 o 0,75 mm
Cable 2x0,5 o 0,75 mm
Installation for sliding gates
-4-
Technical manual
2
2
2
fOTO A
fOTO A2