Webasto Pure Notice D'utilisation Et De Montage page 8

Fault indicators and troubleshooting
- see Fig. 05
Fault
Description
indicator
F1 LED lights yellow for 1 s and green for 2 s:
The charging station has become hot and
charges the vehicle with reduced power.
After a cool-down period the vehicle is again
charged with maximum power.
F2 LED lights yellow:
Excess temperature. Charging stopped due to
high temperature within the charger. After a
cool-down period the charger continues the
normal charging cycle.
F3 LED lights red and a signal sounds for 28 s
and then for 2 s every 10 minutes:
There is a problem in the voltage or system
monitoring.
DANGER
Danger of fatal electric shock
Switch off the power supply to the
X X
charging station.
Contact the Webasto Charging
X X
Hotline under +800-CHARGING
(00800-24274464)
F4 LED lights red for 1 s and green for 2 s:
There is a connection fault in the charging
station, phase monitoring is active, charging
station charges with reduced power.
Have the rotary field checked by an
X X
authorised electrician.
F5 LED flashes red for 1 s at 2 s intervals, a signal
sounds for 28 s and then for 2 s every 10
minutes:
There is a fault in the vehicle.
Re-connect the vehicle.
X X
If the warning persists, contact Webasto
X X
Charging Hotline under +800-CHARGING
(0080024274464)
Webasto PURE
Fault
Description
indicator
F6 LED flashes red for 0.5 s at 0.5 s and 3 s
intervals:
Voltage fluctuations between 180 V and
270 V detected.
Have checked by an authorised electrician.
X X
4.3 Touch control switch (reset)
Do not press but rather only touch the touch control
switch, do not wear gloves.
The touch control switch is used to acknowledge faults.
Action Description
Touch and hold the switch Starts a system self-test and
for at least 10 s. resets failures. After the fault
has been rectified, the char-
ging station switches back to
"standby" mode.
4.4 Key-operated switch
The key-operated switch is used for authorisation purposes
and can be turned through 90°. Turn clockwise to unlock
the charging station. Turn anticlockwise to lock the char-
ging station. See Fig. 07.
The key can be removed in both positions.
4.5 Start charging
Always take into account the vehicle requirements
before charging a vehicle.
Park the vehicle for charging such as to avoid strain in
the charging cable. See Fig. 06.
Action Description
Plug charging coupling The charging station performs
X X
into vehicle and secure. system and connection tests.
LED lights blue then switches
to green:
Charging mode
4.6 Stop charging
Action Description
The vehicle has stopped LED flashes blue at 1 second
the charging cycle auto- intervals. Vehicle connected,
matically: not charging.
Unlock the car.
X X
Unplug the cable from
X X
the vehicle.
Place the connector in
X X
the park position.
Action Description
If the vehicle does not
automatically stop the
charging cycle:
Set key-operated Charging cycle is stopped.
X X
switch to "Off"
LED flashes green and slowly
position.
changes to blue
Or
Stop charging cycle at Charging cycle is stopped.
X X
vehicle.
LED flashes green and quickly
changes to blue.
The charging station can
now be restarted.
5 Transportation and storage
Acclimatization:
Do not open the charging station if the temperature
difference between transportation and installation
location is more than 15 °C. To acclimatise the char-
ging station leave it unopened for at least 2 hours to
prevent condensation forming in the station.
Observe the ambient temperature limits (storage) during
transportation.
Transport the charging station only when suitably pa-
ckaged.
3