Webasto Pure Notice D'utilisation Et De Montage page 6

1 General information
1.1 Purpose of the document
These operating and installation instructions are part of the
product and contain information for the user to ensure safe
operation and for the authorised electrician to carry out
safe installation of the Webasto PURE charging station.
1.2 Using this document
Carefully read the operating and installation instructions
X X
before installing and starting up the Webasto PURE.
Keep these instructions ready to hand.
X X
Hand these instructions on to the following owner or
X X
user of the charging station.
1.3 Intended use
The Webasto PURE charging station is designed for
charging electric vehicles in accordance with IEC 61851-1,
charge mode 3. In this charge mode, the charging station
ensures:
■
■
The voltage is not applied before the vehicle has been
connected correctly.
■
■
The maximum power is calibrated.
The AC/DC converter is in the vehicle.
1.4 Use of symbols and highlighting
DANGER
Hazard with a high degree of risk which, if not avoi-
ded, will lead to death or serious injury.
WARNING
Hazard with a moderate degree of risk which, if not
avoided, may lead to minor or moderate injury.
CAUTION
Hazard with a low degree of risk which, if not avoi-
ded, will lead to minor or moderate injury.
The note denotes a special technical feature or
potential damage to the product.
Reference to separate documentation
Description of a precondition
Description of an action
Webasto PURE
1.5 Warranty and liability
Webasto shall not accept liability for defects or dama-
ge due to the failure to comply with the operating and
installation instructions. This liability exclusion particularly
applies to:
■
■
Improper use.
■
■
Installation and initial operation by a non-authorised
electrician.
■
■
Repairs not carried out by a Webasto service workshop.
■
■
Use of non-original spare parts.
■
■
conversion of the unit without permission from Webasto.
2 Safety
2.1 General information
Only persons over the age of 18 are permitted to use the
charging station.
The Webasto PURE charging station has been develo-
ped, produced, tested and documented according to
the relevant safety and environmental requirements and
regulations. The device must only be used in a technically
faultless condition.
Have any faults that adversely affect the safety of persons
or of the device rectified immediately by an authorised elec-
trician in accordance with nationally applicable regulations.
It is possible that the signalling in the vehicle differs
from that described here. Always refer to the vehicle
documentation.
2.2 General safety information
■
■
Hazardous voltages on the inside.
■
■
Check charging station for visual damage before
use. Do not use the charging station if damaged.
■
■
Installation, electrical connection and initial ope-
ration of the charging station must only be carried
out by an authorised electrician.
■
■
Do not remove the cover over the connections
while the charging station is in operation.
■
■
Do not remove markings, warning symbols and
the rating plate from the charging station.
■
■
The charging cable must only be replaced by an
authorised electrician following the installation
instructions.
■
■
It is strictly prohibited to connect other equip-
ment/devices to the charging station.
■
■
When not in use, store the charging cable in the
designated holder and lock the charging coupling
in the charging station. Loosely wind the charging
cable around the charger casing so that it does
not touch the ground.
■
■
Make sure that the charging cable and coupling
cannot be driven over, trapped and are protected
from any other hazards.
■
■
Immediately notify Webasto Customer Service
if the charging station, charging cable or the
charging coupling are damaged. Do not continue
using the charging station.
■
■
There must be no persons in the vehicle during
the charging procedure.
■
■
Prevent the charging cable and coupling from co-
ming in contact with external heat sources, water,
dirt and chemicals.
■
■
Do not extend the charging cable with extension
cables or adapters to connect to the vehicle.
■
■
Unplug the charging cable only by pulling on the
charging coupling.
■
■
Never clean the charging station with a high-
pressure cleaner or similar device.
■
■
Switch off the power supply before cleaning the
charging sockets.
■
■
Ensure only persons who have read these ope-
rating instructions have access to the charging
station.
2.3 Safety information for installation
■
■
Installation and connection of the charging
station must only be carried out by an authorised
electrician.
■
■
The Webasto PURE safety concept is based on
an power supply system that is earthed at all
times. The authorised electrician must ensure this
requirement during installation.
1