12 After Finishing Work
12 After Finishing Work
12.1 Preparing for Transportation or Storage
To prepare the pressure washer for transportation or
storage:
► Switch off the pressure washer, @ 10.2.
► Disconnect the pressure washer from the power supply.
► Disconnect the pressure washer from the water supply.
► Press the spray gun trigger to relieve any remaining
pressure in the system.
► Lock the spray gun trigger.
► Disconnect the water hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the rest of the water run out
of the spray gun.
► If the pressure washer will be exposed to freezing
temperatures, protect it with antifreeze or take other
measures outlined below, @ 12.2.
► Clean the pressure washer.
7
6
► Wind up the high-pressure hose (1) and stow it on the
bracket (2).
► Roll up the power supply cord (3) and hang it onto the
brackets (4).
► Secure the power supply cord with the clip (5).
► Insert the detergent spray set (6).
0458-002-8221-A
► Insert the nozzle (7).
► Place the spray attachment in one of the holders (8).
12.2 Protecting the Pressure Washer in Winter
Removing Water from the System
To remove any remaining water from the system:
► Switch off the pressure washer, @ 10.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
1
► Relieve system pressure.
2
► Remove the high-pressure hose, @ 8.2.2.
► Disconnect the water hose, @ 9.
► Drain the water out of the high-pressure hose and water
hose.
► Connect the power supply cord to a properly installed
3
4
electrical outlet that matches the voltage and electrical
5
frequency stated on the pressure washer's rating plate.
► Switch on the pressure washer and let the pump run for up
to 30 seconds until the water flow stops. Remaining water
will be eliminated from the system.
► Switch off pressure washer and disconnect it from the
power supply.
8
8
8
Conditions
English
8
8
27